james
New Member
Posts: 5
|
Post by james on Apr 15, 2020 18:52:52 GMT
Hi everybody, I've looked everywhere. I'm putting my cylinder back on my pe400 after a rebore and I want the torque specs for the four 10mm cylinder to crankcase nuts. I also removed the six studs at the top of the cylinder that the head is secured with and need to know the torque to reinstall those. All the manual gives you is the head nuts torque and that's 14.5~18 lb-ft. thanks
|
|
james
New Member
Posts: 5
|
Post by james on Apr 17, 2020 18:07:40 GMT
After reading many posts of other 2 stroke dirtbikes I've come to the conclusion that the torque specs might be around 24 lb-ft for the cylinder base nuts and 9 lb-ft(with threadlocker) for the cylinder studs.
|
|
Admin
Full Member
Posts: 146
|
Post by Admin on Apr 18, 2020 13:42:22 GMT
After reading many posts of other 2 stroke dirtbikes I've come to the conclusion that the torque specs might be around 24 lb-ft for the cylinder base nuts and 9 lb-ft(with threadlocker) for the cylinder studs. It's an oversight, I checked several Clymer Suzuki manuals too and didn't find anything other than tighten them evenly. I would check them again after the first ride. This generic bolt tightening list is all I have for reference. www.dropbox.com/s/ih66vu07ywsp8ji/IMG_0275-squashed.jpg?dl=0
|
|