|
Post by rjmorel on Feb 14, 2020 0:07:53 GMT
I'm trying to remove the flywheel of my 82 PE175. Not budging. I've made a puller like the manual shows that screws into the 3 holes on the flywheel and uses a slide hammer to pop it off. Also used a bolt going through the puller to the end of the crank that I tighten then hit end of bolt with hammer and they usually pop right off. Have any of you experienced this and have a hard time getting them off? It was running fine yesterday but want to pop flywheel off and see how everything is as I see some rust corrosion going on. thanks Rob
|
|
Admin
Full Member
Posts: 146
|
Post by Admin on Feb 14, 2020 1:16:06 GMT
|
|